Corgi With Floppy Ears: 10 Step to Straighten Them
Some dog owners believe taping their corgi’s ears will make the dog stand up. It is wrong as taping them for too long will cause pain and possibly injury to your pet. The main method how to make a corgi’s ear stand up was by taping, but it won’t work unless you do this safely. Tape can be dangerous if left on longer than needed because it could increase the risk of infection or damage the tissue, which causes the skin to be pulled and, in worst cases, tears.
Some taping techniques will leave it unsafe for your puppy’s ears; however, some may work well, but you must still know how to do it correctly.
Step one: Take the dog’s ears and clean them thoroughly. It will prevent infection and damage to the corgi’s ears.
Step two: Use a masking tape to hold the corgi’s ears in place. Start by putting a piece of masking tape all around, going to both sides and the base of your dog’s head. Then, stick one end inside each ear ears are usually flesh-colored, so it shouldn’t be confusing
The kind we use comes with Velcro strips that you attach to both ears. You then wrap these pieces of Velcro around themselves twice. With your thumb and index finger, gently pull the tape until it’s taut. Then, hold the tip of the tape with your fingers to easily slide it over your puppy’s ears. While holding corgi ears, take the tape and press it against his head.
Step three:
- Pull off the excess tape.
- Put the new piece on his head.
- Pull up your puppy’s ears and then gently let go.
It will keep it in place for the time being, but you may need to do this occasionally throughout your puppy’s life as he grows up and his ears change.
Step four:
- Hold onto one ear at a time to stand upright on their dogs’ instincts and apply firm pressure down towards the base of his skull behind both ears using a pencil eraser or tape measure.
- Tighten the tape. If you’re feeling brave, give it a treat as well.
- Repeat this step with the other ear.
- Carefully peel off the masking tape and throw it away. The corgi will now look like a Corgi.
Step five: Now that we have the ear pressed, we can tie the collar. Take your rope or ribbon and go around your puppy’s neck twice with about one inch between each loop of string but not too tight; this will allow him to breathe easily. It is also an important step because you don’t want pressure on his windpipe, which can cause breathing problems that may lead to serious health problems.
Step Six: Pretend that you’re tying your shoelaces for the second time; you might want to get help from someone else, but it doesn’t have to be like a slavish act of copying exactly what we do; in these directions, so don’t hesitate! The main point is that this collar should fit loosely enough around your dog’s neck and yet firm enough that it hasn’t pulled back off and be uncomfortable. If your dog finds the collar too tight, it might rebel against wearing it or start to pull at his new look!
Step seven: After you’ve made a couple of knots in one end, tie both ends together with some more rope so that he can struggle without tangling himself up in the process for eternity. All kidding aside, though, this will help him get used to wearing this now permanent collar.
Step eight: Your dog will be more relaxed after the operation, but he might still react to his new ear from time to time. It could be due simply to a sore spot on his neck, but it is still likely that he will act up and alternate between the stylish new look with a low growl or barking fit whenever someone approaches him. Therefore it’s in your best interest not to let those around you worry about these squeaks or seizures; reassure them as though nothing has changed.