Sometimes you may be wondering and curios to know how to program clean remote and how it works, find no website again as I will be reveal to you the best guide on how to do so.

How To Program Clean Remote

Step 1: Install Batteries

• Open Cover: With Keypad facing you, first slide dark lens cover away from you (photo A, Step 1) and then lift lid upwards from the back (photo A, Step 2).
• Insert two AAA batteries into the remote as shown below in photo
• Close cover with keypad facing away from you by pressing downward (phot C, Step 1) and sliding it toward the front until it is (photo C, Step 2).
• Test Remote by pressing the power button; the LED should light indicating that the batteries are in

If LED doesn’t light, then the batteries are either in wrong or the batteries are bad.

 

 

Step 2: Program to TV

• Turn on your TV and then stand back approximately 3-5 feet and point the remote at the CENTER of the front

of your TV.

• Press and firmly HOLD down the SETUP button, do not release. The LED will blink once and then after 7 seconds it will initiate code The LED will continue to blink every 2 seconds. Once your TV shuts off immediately remove your finger from the SETUP button; the code automatically locks in.
• Turn TV Test the VOLUME to ensure it works properly. If volume works correctly move to STEP 3.

Do You Need A PC For A Monitor?

Step 3: Program to Set Top Box

• With your TV on turn your TV to Channel 3
• While pointing the remote at the set top box press and firmly HOLD down the ” button, do not release. The LED will blink once and then after 7 seconds it will initiate code The LED will continue to blink every 2 seconds. Once your TV turns to a new channel immediately remove your finger from the ” button; the code automatically locks in.
• Test the remote by turning channels to ensure it works properly. If you are unable to change channels repeat Step

Trouble Shooting

Important Note: If you think you missed the TV code or you intend to use the remote on a
different brand TV: Reset the remote back to the TV factory default and beginning of the TV code
search: Press and hold the SETUP button down, then press and hold the CC button down at the same
time until the red LED light blinks quickly 3 times, then release both buttons. You have now reset the
code list back to the beginning. Then see Easy TV Setup on page 1.

Reset remote to work TV only without a cable box.

If you’ve already set up the remote to work both a TV and a Cable Box and now wish to operate TV only
without a cable box. Hold down the button and SETUP button together until the remote blinks 3 times
quickly and immediately release both buttons. Then follow the Reset instruction in the above paragraph.

 

FAQs

 

How do I automatically program my TV remote?

You may set up your TV remote control automatically in a few different ways. One method is to keep pressing the TV’s power button for five seconds until it shuts off. After turning it off, let go of the button and press it once more. The TV will enter programming mode as a result. Following that, look up the code for your TV remote in the user handbook and enter it using the number buttons.

How do you use a clean remote control?

You can wipe off the surface of a remote control with a moist cloth to clean it. You can use a toothpick or a needle to remove any dirt or dust specks from the remote. To clean the nooks and crannies in between the buttons, you can use use a little brush.

How do you program a remote to a TV with a code?